Published at Sunday, June 24th, 2018 - 10:32:58 AM. Lamp. By Searlait Evonne.
If you are putting up a hanging lamp, this is the time to add the chain and the additional wire so it hangs where you want it. Using the pliers first add the additional chain. All you have to do is open one of the links add the new chain and close it up again. To add the electric wire, peel about one inch of plastic cover from each wire and tie it tightly with the wire already attached to the lamp. Cover each individually with electric tape and add another layer covering both wires together. Take down the original lamp and set it aside, bring up the new one and tie each lamp wire to one of the wires hanging from the ceiling. It does not matter which wire you tie with each wire on the ceiling, the lamp will work anyway. Again make the knots between wires tight, cover them individually with electric tape with a final covering of both wires. Put the lamp holder through the hole on the base that is screwed to the ceiling, and tighten the nut holding the lamp firmly against the ceiling.
Table lamps come in different heights and widths. When it comes to height, most of them range from 25" to 32". The widths vary depending on the type of lamp where candlestick lamps are the thinnest. The size of lamp that you go with depends on the size of your table. If planning of placing the lamp on a narrow, delicate table, go with a slender lamp. In addition to the lamp looking beautiful on such a table, it's also safe.
Any content, trademark’s, or other material that might be found on the Thedatacenters.com website that is not Thedatacenters.com’s property remains the copyright of its respective owner/s. In no way does Thedatacenters.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.