Published at Sunday, June 24th, 2018 - 10:31:37 AM. Lamp. By Tallis Carressa.
This procedure applies to a fixed lamp on the ceiling or on the wall. As always please remember to work slowly and pay attention to what you are doing. Safety should be your main concern. In this case you will need a folding ladder that should go all the way up to the lamp; you must also be able to stand on it without going all the way to the top. Please use a good ladder and make sure it is safe and does not wobble before getting on it. You will need our usual set of tools too, pointed electrical pliers, a screwdriver, electrical tape and a new one, a small wrench.
If you are putting up a hanging lamp, this is the time to add the chain and the additional wire so it hangs where you want it. Using the pliers first add the additional chain. All you have to do is open one of the links add the new chain and close it up again. To add the electric wire, peel about one inch of plastic cover from each wire and tie it tightly with the wire already attached to the lamp. Cover each individually with electric tape and add another layer covering both wires together. Take down the original lamp and set it aside, bring up the new one and tie each lamp wire to one of the wires hanging from the ceiling. It does not matter which wire you tie with each wire on the ceiling, the lamp will work anyway. Again make the knots between wires tight, cover them individually with electric tape with a final covering of both wires. Put the lamp holder through the hole on the base that is screwed to the ceiling, and tighten the nut holding the lamp firmly against the ceiling.
Any content, trademark’s, or other material that might be found on the Thedatacenters.com website that is not Thedatacenters.com’s property remains the copyright of its respective owner/s. In no way does Thedatacenters.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.